Ariston Clas 24 FF Informations techniques Page 19

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 40
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 18
19
messa in funzione commissioning
Deaeration cycle
During the  lling stage or if there is excess air in the system, the deaeration
cycle can be activated by holding the ESC button for 5 seconds. The
boiler will start a cycle which lasts approximately 7 minutes. When this
is complete the menu screen will be restored. The cycle may either be
repeated, if necessary, or stopped by pressing ESC. Press the ESC button
until the normal display screen is restored.
Funzione Disareazione
Premendo il tasto ESC per 5 secondi la caldaia attiva un ciclo di disareazione
di circa 7 minuti. La funzione può essere interrotta premendo il tasto
ESC. Se necessario è possibile attivare un nuovo ciclo. Veri care che la
caldaia sia in Stand-by, nessuna richiesta dal circuito riscaldamento o dal
sanitario.
- accendere la caldaia (premendo il tasto ON/OFF) e selezionare la
modalità stand-by, non ci sono richieste né dal sanitario né dal
riscaldamento.
- attivare il ciclo di disareazione premendo il tasto ESC per 5
secondi. Esc. La caldaia inizierà un ciclo di disareazione di circa 7
minuti.
- al termine veri care che l’impianto si completamente disareato
e, in caso contrario, ripetere l’operazione.
- spurgare l’aria dai radiatori
- aprire l’acqua calda sanitaria  no allo s ato completo del
circuito
- il condotto di evacuazione dei prodotti della combustione sia
idoneo e libero da eventuali ostruzioni.
- le eventuali necessarie prese di ventilazione del locale siano
aperte (installazioni di tipo B).
2. Aprire il rubinetto del gas e veri care la tenuta degli attacchi
compresi quelli della caldaia veri cando che il contatore non
segnali alcun passaggio di gas. Eliminare eventuali fughe.
3. Mettere in funzione la caldaia attivando il funzionamento
invernale o estivo.
- Switch on the boiler (by pressing the ON/OFF button) and select
the standby mode, where no hot water or heating requests are
made.
- Start the deaeration cycle by pressing ESC for 5 seconds
The boiler will start a deaeration cycle lasting about 7 minutes. If
you need to stop it press E
SC.
- At the end, check that the system is completely deaerated and, if
not, repeat the procedure.
- Bleed the air from the radiators;
- The exhaust duct for combustion products should be suitable
and free from any obstructions;
- Any necessary ventilation inlets in the room should be open (type
B installation).
2. Open the gas valve and check the connection seals, including
the boiler connection seals, making sure that the meter does not
detect any passage of gas. Eliminate any leaks.
3. Start the boiler by selecting the heating or domestic hot water
operation.
Funzione Spazzacamino
La scheda elettronica consente di forzare l’apparecchio alla
massima o alla minima potenza.
Attivando la funzione
Spazzacamino, premendo il tasto
Reset per 5 secondi, la caldaia
verrà forzata alla massima potenza
riscaldamento, sul display appare:
Per selezionare il funzionamento
alla massima potenza sanitario
premere il tasto
sul display
appare:
Per selezionare il funzionamento
alla minima potenza premere il
tasto , sul display appare:
Tale funzione si disattiva automaticamente dopo 10 minuti o
premendo il tasto RESET.
Nota: E’ possibile forzare la caldaia alla massima e alla minima
potenza anche accedendo al menù 7 (vedi paragrafo menù
impostazione - regolazione - diagnostica).
Chimney sweep function
The P.C.B. enables the boiler to be forced to its maximum or
minimum power.
By activating the Chimney sweep
function, pressing the Reset button for
10 seconds, the boiler will be forced to its
maximum heating power and the display
shows:
To select hot water operation at maximum
power, press the
button and the
following will appear on the display:
To select hot water operation at minimum
power, press the
button and the
following will appear on the display:
This function is deactivated automatically after 10 minutes, or
when the RESET button is pressed.
Note: The boiler can also be forced to its maximum and minimum
power by accessing menu 7 (see settings - adjustment - problem
identi cation menu paragraph).
Vue de la page 18
1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 39 40

Commentaires sur ces manuels

Pas de commentaire